Neutral Powe - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Neutral Powe - Nissan 240SX 1991-1992 Workshop Manual
Neutral Powe
SUPER HICAS SYSTEM — On-vehicle Inspection Inspection of HICAS System Operation (Cont'd) —
4. Operate engine at speeds greater than 2,000 rpm, and turn steering wheel 180° in one direction from the neutral
Neutral Powe
position. Measure extension value of one power cylinder
rod and retraction value of the other. Then, turn steering U Stroke wheel 180° in the other direction from the neutral position, (S) aed |
and measure extension value of one cylinder rod and
iff | Wt
retraction value of the other. Determine strokes of respec-
Jia tive power cylinder rods by adding (measured) extension —_—_— oN! and retraction values. Measure rod strokes in as short a period of time as possible. SST378B Specifications: When turned to the right 3 mm (0.12 in) When turned to the left 3 mm (0.12 in) Total stroke 6 mm (0.24 in) Do not depress foot brake pedal during operation check, otherwise the operation will be stopped.
Bleeding Hydraulic System Before bleeding air from the HICAS system, be sure to bleed air from the power steering system. Refer to “SUPER HICAS SYSTEM — Repair of Component Parts’’.
SST709B
ST-33
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.