SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
SUPER HICAS SYSTEM — Trouble Diagnoses
SUPER HICAS SYSTEM — Trouble Diagnoses
Preliminary Check (Cont'd)
CHECK 3
@ SIMULATED DRIVE TEST
Perform rear wheel action check. fm SELECT MONITOR ITEM
MAIN SIGNALS
When CONSULT is used:
| SELECTION FROM MENU
|
1. Have a helper sit in the driver’s compartment, and raise L_ | vehicle. L | (Use a two-pole lift or a center pole lift so that the four L START ! wheels are free to rotate.) 5613768
2. Connect CONSULT unit to diagnostic connector and start engine.
3. Touch “START’’ on CONSULT display.
4. Touch “HICAS”, “ACTIVE TEST” and ‘SIMULATED DRIVE” in that order.
5. Touch “START” when “MAIN SIGNALS” display is re- versed.
6. Touch “START.” Bactivetest® [|] After simulated drive condition has continued for 5 minutes, it will automatically cancel and CONSULT unit will then show CeNDITION eee
“TEST IS INTERRUPTED TO AVOID OIL TEMP RISE” display. To
==> =MONTOR => = =
cancel this mode during self-diagnosis, simply touch
STEERING ANG
R11° “CANCEL”.
HICAS SOL
RO.58A
| CANCEL | SST708B
7. While running engine at speeds greater than 2,000 rpm, turn steering wheel 180° to the left and right from the neutral position. Ensure that rear wheels steer in response to rotation of steering wheel.
y a SST460B
ST-49
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.