Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

FUEL INJECTION CONTROL SYSTEM INSPECTION - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › FUEL INJECTION CONTROL SYSTEM INSPECTION - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXFUEL INJECTION CONTROL SYSTEM INSPECTION - Nissan 240SX 1991-1992 Workshop Manual

FUEL INJECTION CONTROL SYSTEM INSPECTION

FUEL INJECTION CONTROL SYSTEM INSPECTION

Releasing Fuel Pressure Before disconnecting fuel line, release fuel pressure from fuel line to eliminate danger. Perform “FUEL PRESSURE RELEASE”’ in “WORK SUPPORT”’ mode with CONSULT.

Diagnostic connector q for CONSULT MINI} SEF836K

W@ FUEL PRES RELEASE @

FUEL PUMP WILL STOP BY

TOUCHING START IN IDLING.

CRANK A FEW TIMES AFTER

ENGINE STALL.

START [ SEF952J . Remove fuel pump fuse. . Start engine. . After engine stalls, crank it two or three times to release all fuel pressure.

4. Turn ignition switch off and reconnect fuel pump fuse. Fuel pump fuse (10A)

SEF743K

Fuel Pressure Check

a. Make sure that clamp screw does not contact adjacent parts.

b. Use a torque driver to tighten clamps.

c. Use Pressure Gauge to check fuel pressure.

d. Do not perform fuel pressure check while fuel pressure regulator control system is operating; otherwise, fuel pres- sure gauge might indicate incorrect readings.

1. Release fuel pressure to zero.

2. Disconnect fuel hose between fuel filter and fuel tube (engine side).

3. Install pressure gauge between fuel filter and fuel tube.

4. Start engine and check for fuel leakage.

EF & EC-171

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.