Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 13 — Engine Stalls when

mw Active test g@

LJ

Stepping on the Accelerator Momentarily

AAC/V OPENING

50% No

CHECK A.A.C. VALVE.

Check A.A.C. valve and >, fe) le Select ‘‘A.A.C. VALVE circuit. (See page EF &

825rpm

CAS-RPM (REF)

AIR FLOW MTR

‘1.12V OPENING” in “ACTIVE TEST” EC-162.)

ENG TEMP SEN

gsec mode.

2. When touching “‘Qu”’ and [Qu|l UP

|| DWN |/Od}

‘“‘Qd’’, does the engine speed change according to the per- SEF730K cent of * ~ C. valve opening?

When disconnecting A.A.C.

3 valve harness connector, does 2ae the engine speed drop? Yes v No Go to fj.

PERFORM POWER BALANCE TEST.

Vv oy

1. Perform ““POWER BALANCE” in “ACTIVE TEST” mode. Ca

2. Is there any cylinder which SEF 1461 does not produce a momen- tary enone speed drop?

When disconnecting each injec-

Mactive test m@

[]

# & & POWER BALANCE * * *

tor harness connector one at a <scSSs MONITO > —¥——) time, is there any cylinder which

CAS-RPM (REF)

712rpm

AIR FLOW MTR

‘1.02V does not produce a momentary

AAC VALVE

37% engine speed drop? M2

Le test

Yes LL

IL LIL

¥ No

CHECK INJECTOR.

Check injector(s) and Vv SEF729K

1. Remove distributor assembly from their circuit(s). engine. (Crank angle sensor harness Tae connector should remain connected.) OtSCONNECT

2. Disconnect ignition coil harness con- nector.

3. Turn ignition switch ON. (Do not start engine.)

4. When rotating crank angle sensor shaft, does each injector make an operating sound? Fuel injector connector PA // \ SEF738K (Go to @ on next page.)

SEF837K

EF & EC-79

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.