Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

DISCHARGING, EVACUATING, CHARGING AND CHECKING

DISCHARGING, EVACUATING, CHARGING AND CHECKING

Work Procedure i In service A/C system | i Vv | When it is necessary to replace parts. | | When it is not necessary to replace parts. ¥ i Check the spot where malfunction Check the spot where refrigerant leaks. occurs. ‘ | Repair. | [ Discharging*1 ~ ¥ | | Add refrigerant. | Replace parts. y New A/C system |__| Install the service tools. Install the A/C system. v Evacuating Run pump for over 5 minutes. Y Repair LNG. | Checking airtightness Shut off the high and low pressure * valves of the manifold gauge, and leave system as it is for 5 to 10 min- utes. yok. Evacuating*2 Run pump for over 20 minutes. Y Charging Charge approx. 200 g (7.05 oz) re- frigerant from high pressure side (with engine shut off). v Preliminary refrigerant leak check | N.G. » yok. Charging Charge a specified amount of refrig- erant from high pressure side (with engine shut off).

| Checking refrigerant leaks yok. Checking amount of refrigerant Start engine, and check after in- creasing engine speed to 1,500 to 2,000 rpm. ¥ *1: Do not discharge refrigerant Check operation of A/C system. into the air. Capture all refrig- _y erant in your recycling equip- Remove service tools. ment. Use care not to allow refrigerant to *2: Working operation depends leak out when removing. Make sure upon the performance of the that refrigerant remaining in service pump and the weather. canister is not leaking.

HA-26

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.