REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
Reverse Clutch (Cont'd)
3. Remove drive plates, driven plates, retaining plate, dish plate and snap ring.
SAT842A
4. Remove snap ring from clutch drum while compressing KV31102400 (J34285 and clutch springs. J34285-87) Do not expand snap ring excessively. a) Remove spring retainer and return spring.
SAT843A
6. Install seal ring onto oil pump cover and install reverse clutch drum. While holding piston, gradually apply com- pressed air to oil hole until piston is removed. @ Do not apply compressed air abruptly.
7. Remove D-ring and oil seal from piston. INSPECTION Reverse clutch snap ring and spring retainer @ Check for deformation, fatigue or damage. SAT844A Reverse clutch return springs
@ Check for deformation or damage. Also measure free length
and outside diameter. diameter Inspection standard: Outer : D Unit: mm (in)
| Parts | Part No. | Q | D |
|---|---|---|---|
| Spring | 31505-41 X02 | 19.69 (0.7752) | 11.6 (0.457) |
: Free length Q
SAT829A Reverse clutch drive plates Thickness @ Check facing for burns, cracks or damage. @ Measure thickness of facing. Thickness of drive plate: Facing Standard value: 2.0 mm (0.079 in) Wear limit: 1.8 mm (0.071 in) @ If not within wear limit, replace. a Core plate Reverse clutch dish plate @ Check for deformation or damage. SAT845A AT-134
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.