REMOVAL AND INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REMOVAL AND INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual
‹ Prev ON-VEHICLE SERVICE (Final drive) - Nissan 240SX 1991-1992 Workshop ManualNext › FINAL DRIVE (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREMOVAL AND INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual
REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
Removal
\ @ Remove propeller shaft.
Insert plug into rear oil seal after removing propeller shaft. _ @ Remove drive shafts. (
Refer to RA section.
NOX/ — @ Pull off final drive backward together with jack.
CAUTION: - @ Be careful not to damage spline, sleeve yoke and front oil © ()
seal, when removing propeller shaft.
e After final drive is removed, support suspension member SPD881 on a stand to prevent its insulators from being twisted or damaged.
Installation @ Fill final drive with recommended gear oil.
Oil level
Filler opening spDss2
PD-11
‹ Prev ON-VEHICLE SERVICE (Final drive) - Nissan 240SX 1991-1992 Workshop ManualNext › FINAL DRIVE (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.