Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

LINE PRESSURE SOLENOID CIRCUIT CHECK

Line pressure solenoid | . | Terminal N.G.

CHECK GROUND CIRCUIT.

1. Remove control valve assem- cord ~~ bly. — Refer to ‘‘ON-VEHI- ? assembly , @

CLE SERVICE”.

| Dropping

. Check the following items. NO resistor Line pressure solenoid — @

2. Disconnect terminal cord Refer to “Electrical Com- 1 2 assembly connector in engine ponents Inspection’’. A/T control unit compartment. Harness continuity of terminal @

3. Check resistance between SAT974B cord assembly terminal (1) and ground. Solenoids Resistance: 2.5 - 522 1 TS. harness BI O.K. connector DISCONNECT | R N.G. Check the following items.

CHECK POWER SOURCE

® Dropping resistor — Refer to CIRCUIT. “Electrical Components T @ Inspection’. ae @ Harness continuity between

A/T control unit @) and

2. Disconnect A/T control unit terminal cord assembly SAT977D connector.

3. Check resistance between aa Solenoids 8)

terminal (@) and A/T control

a [ harness TS unit terminal Q). I connector _ DISCONNECT Resistance: 11.2 - 12.822 ©) fom O.K. v N.G.

CHECK POWER SOURCE

Repair or replace harness

between A/T control unit @

CIRCUIT | and terminal cord assembly. & __/ ‘

2. Check resistance between

terminal @) and A/T control

— DISCONNECT unit terminal). Yoo) a €) Resistance: Approximately 022

[__e7untt_|ol CoNNecToR |

3. Reinstall any part removed. 1 2 O.K. Vv N.G. 1 OR/B Perform self-diagnosis after

1. Perform A/T control unit driving for a while. input/output signal inspection.

2. If N.G., recheck A/T control SAT978D O.K. unit pin terminals for damage v or connection of A/T control

INSPECTION END

unit harness connector.

AT-55

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.