SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
SUPER HICAS SYSTEM — Trouble Diagnoses
SUPER HICAS SYSTEM — Trouble Diagnoses
Diagnostic Procedure 11
SYMPTOM: Inhibitor switch (A/T) or neutral switch (M/T) input is not present. START A y O.K.
CHECK CONNECTOR CONTINU-
Poor:connector connection Vv ITY. Disconnect control unit connec- SST430B tor and reconnect it firmly. Con- duct self-diagnosis. N.G. Ei ¥
SYMONITOR ¥YNO FAIL
CAR SPEED (REF)
Okm/h’ O.K.
CHECK CONTROL UNIT
Replace control unit.
STEERING ANG
Lg° Vv
INPUT SIGNAL.
NEUTRAL SIG
ON
STOP LAMP SW
OFF Set CONSULT in DATA
PKB/CLUTCH SW
ON MONITOR mode.
NEUTRAL SW
ON ON-OFF display
ENG REV
UNDER 1500
HICAS SOL
RO.OOA OR Measure voitage varia- ®) | RECORD | tions between control unit terminals and @4)
Ye MONITOR #yNO FAIL
[4] when shift lever is moved FAILSAFE/V OFF from P to any other posi- FAILSAFE NON tion (A/T) or shift lever is
WARNING LAMP
OFF moved from neutral to any other position (M/T). Voltage: OV — Approximately 5V N.G. | RECORD Vv Check inhibitor switch or neutral switch and harness. SST728B
CONNECT =
0 fo) 14 24]
G/OR B @ e DO SST747B
ST-78
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.