BRAKE BOOSTER - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › BRAKE BOOSTER - Nissan 240SX 1991-1992 Workshop Manual
‹ Prev BRAKE PEDAL AND BRACKET - Nissan 240SX 1991-1992 Workshop ManualNext › BRAKE BOOSTER - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXBRAKE BOOSTER - Nissan 240SX 1991-1992 Workshop Manual
BRAKE BOOSTER
BRAKE BOOSTER
Removal and Installation
Clevis pin
(0) 13 - 16 (1.3 - 1.6, 9 - 12)
() : N-m (kgm, ft4b) Brake booster O) 8-11 SBR473A (0.8 - 1.1, 5.8 - 8.0) Inspection
OPERATING CHECK
@ Depress brake pedal several times with engine off, and
check that there is no change in pedal stroke.
@ Depress brake pedal, then start engine. If pedal goes down
slightly, operation is normal.
SBROO2A
AIRTIGHT CHECK
@ Start engine, and stop it after one or two minutes. Depress
brake pedal several times slowly. If pedal goes further down
the first time and gradually rises after second or third time,
booster is airtight.
@ Depress brake pedal while engine is running, and stop
engine with pedal depressed. If there is no change in pedal
stroke after holding pedal down 30 seconds, brake booster
is airtight.
OUTPUT ROD LENGTH CHECK
1. Supply brake booster with vacuum of -66.7 kPa (-500
mmHg, —19.69 inHg) using a handy vacuum pump.
2. Check output rod length. Output rod Specified length: length
10.275 - 10.525 mm (0.4045 - 0.4144 in)
SBR281A BR-8
‹ Prev BRAKE PEDAL AND BRACKET - Nissan 240SX 1991-1992 Workshop ManualNext › BRAKE BOOSTER - Nissan 240SX 1991-1992 Workshop Manual
Parts & tools for this job For Nissan 240SX
- PARTBrake padsSearch: Nissan 240SX brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.