PARKING BRAKE CONTROL - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › PARKING BRAKE CONTROL - Nissan 240SX 1991-1992 Workshop Manual
PARKING BRAKE CONTROL
PARKING BRAKE CONTROL
Removal and Installation
J, R.H. rear cable
-— Lock plate
Control lever
S Ga “e “4 Cr \A 4,D5)
— cable ~l, pe \) pe | (| ys
SBR487A REMOVAL @ Before removing parking brake control, remove console box.
Clinched portion
|
@ Loosen cable using control lever adjuster, and separate
a mi front and rear cables. ~~ ><>
@ Break clinched portion of control lever using
a hammer and
chisel as shown in figure at left, and replace cables with new parts.
Front cable | Apply multi-purpose grease to areas between control lever
Control lever drum and cables. SBR488A INSTALLATION Be careful not to damage boot and inner cable. @ When installing parking brake cable at rear caliper, make sure to align matchmark on parking cable stay and cable.
Cable guide Matchmark
Cable _ cutout portion SBR489A Inspection
1. Check control lever for wear or other damage. Replace if necessary.
2. Check parking brake cables, lamp and switch: Replace if necessary.
3. Check parts at each connecting portion for deformation or damage. If found, replace.
BR-20
Parts & tools for this job For Nissan 240SX
- PARTBrake padsSearch: Nissan 240SX brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.