CHARGING SYSTEM — Alternator — - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CHARGING SYSTEM — Alternator — - Nissan 240SX 1991-1992 Workshop Manual
CHARGING SYSTEM — Alternator —
CHARGING SYSTEM — Alternator —
Brush Check (Cont’d)
3. Check brush lead wire for damage. e Damaged ... Replace. 2 mm (0.08 in)
4. Check brush spring pressure. Measure brush spring pressure with brush projected ap- proximately 2 mm (0.08 in) from brush holder. Spring pressure: Refer to S.D.S. e Not within the specified values ... Replace.
EE049
Stator Check
[MITSUBISHI make] Long nose pliers To test the stator or diode, separate them by unsoldering the used as a heat sink connecting wires.
CAUTION: Use only as much heat as required to melt solder. Otherwise, diodes will be damaged by excessive heat. \
SEL054D
1. Continuity test [MITSUBISHI make] e No continuity ... Replace stator. Lead wire LL] = O Ohmmeter CN Oo
SEL475P [HITACHI make]
SEL959N
2. Ground test e Continuity exists ... Replace stator.
Ohmmeter
core SEL476P EL-26
Parts & tools for this job For Nissan 240SX
- TOOLBattery testerSearch: car battery tester
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBattery terminal cleanerSearch: battery terminal cleaner
As an Amazon Associate we earn from qualifying purchases.