WIPER AND WASHER - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › WIPER AND WASHER - Nissan 240SX 1991-1992 Workshop Manual
WIPER AND WASHER
WIPER AND WASHER
Wiper and Washer Adjustment
INSTALLATION 1, Prior to wiper arm installation, turn on wiper switch to operate wiper motor and then turn it “OFF”’ (Auto Stop). Lift the blade up and then set it down onto glass surface to set the blade center to clearance “L:” & “L2"’ immediately before tightening nut.
Eject washer fluid. Turn on wiper switch to operate wiper motor and then turn it “OFF”.
-
Ensure that wiper blades stop within clearance ‘‘L,” & “L.”.
Clearance “L,”: 17.5 - 32.5 mm (0.689 - 1.280 in)
Clearance “L.”: 25 - 35 mm (0.98 - 1.38 in)
Tighten wiper arm nuts to specified torque.
Front wiper: 17 - 23 N-m (1.7 - 2.3 kg-m, 12 - 17 ft-Ib)
Rear wiper: 13 - 18 N-m (1.3 - 1.8 kg-m, 9 - 13 ft-Ib)
*1: 503 (19.80) *2: 275 (10.83) *3: 425 (16.73) *4: 213 (8.39) *5: 144 (5.67) ey,
Clearance “L, ” YZ,
*6: 155 (6.10) *4 *3
Clearance ‘’L,”’
*7: 273 (10.75) *9 x 1 _—-— 7 *8: 385 (15.16) | 4 Unit: mm (in) * All the diameters of these circles are less than 80 (3.15). *7 *8 Glass end SEL425L
*1: 93 (3.66) *2: 85 (3.35) *3: 38 (1.50) *4: 25 (0.98) Unit: mm (in)
SEL414L
EL-75
Parts & tools for this job For Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.