CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
CYLINDER BLOCK
CYLINDER BLOCK
Inspection
PISTON AND PISTON PIN CLEARANCE
1. Measure inner diameter of piston pin hole ‘‘dp’’. Standard diameter ‘‘dp’’:
20.987 - 20.999 mm (0.8263 - 0.8267 in)
SEM149B
2. Measure outer diameter of piston pin ‘‘Dp’’. Standard diameter ‘“‘Dp”’:
20.989 - 21.001 mm (0.8263 - 0.8268 in)
3. Calculate interference fit of piston pin to piston. dp — Dp = 0 - 0.004 mm (0 - 0.0002 in) If it exceeds the above value, replace piston assembly with pin.
Micrometer SEM821B
PISTON RING SIDE CLEARANCE
Side clearance: Top ring
0.040 - 0.080 mm (0.0016 - 0.0031 in) 2nd ring Feeler
0.030 - 0.070 mm (0.0012 - 0.0028 in) gauge Max. limit of side clearance:
0.1 mm (0.004 in) If out of specification, replace piston and/or piston ring assem- Feeler gauge O.K. bly. Ring SEM249C
PISTON RING END GAP
End gap: Piston Top ring — 9
0.28 - 0.52 mm (0.0110 - 0.0205 in) 2nd ring
0.45 - 0.69 mm (0.0177 - 0.0272 in) Oil ring
0.20 - 0.69 mm (0.0079 - 0.0272 in) Max. limit of ring gap:
1.0 mm (0.039 in) If out of specification, replace piston ring. If gap still exceeds the limit even with a new ring, rebore cylinder and use oversized piston and piston rings. Refer to S.D.S.
EM-36
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.