SUN ROOF - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUN ROOF - Nissan 240SX 1991-1992 Workshop Manual
SUN ROOF
SUN ROOF
Electrical Sun Roof (Cont'd)
Finisher plate removal & installation Remove guide rail cover and pull up pawl, then . ; . draw out finisher plate with sun roof lid open. . Link & wire removal & installation When replacing wire, remove BI @ rail first and then link & Link & wire assembly wire assembly. e Be sure to lubricate. Guide rail cover Link & wire
\ assembly
Paw retaining rivet
Draw out Pawl plate.
y 4am, finisher
Pulling up pawl
Finisher plate Retainer bracket Vy Removal: Raise pawl of retainer bracket, Pawl shift finisher plate and remove Retainer . .
Glass lid adjustment
bracket
locating pins from retainer
bracket.
Then remove finisher plate.oN
Locating 8 pin
Link & wire assembly Adjusting shim Retainer bracket [t = 1.0 mm (0,039 in)] Pawl Finisher plate
Link & wire adjustment [p) Move link & wire assembly to closed lid position and after closing fully (as shown in figure below), install motor. Link & wire assembly a Lf Sse Deflector Link guide J bracket Front stopper oe) i \ 4 | K— pw,
\Coron stopper
Guide rail
Guide rail —_
4
Wire guide assembly
L.H. side
SBF187E BF-69
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.