Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Basic Inspection (Cont'd)

|

BM IGN TIMING ADJ g CL]

N.G.

CHECK IDLE ADJ. SCREW INITIAL SET

> Adjust engine speed by

—- CONDITION SETTING --

turning idle adjusting RPM.

IGN/T FEEDBACK: HOLD

1. Select “IGN TIMING ADJ” in screw. “WORK SUPPORT” mode. MONITOR —

CAS+RPM (REF)

650rpm

2. When touching ‘‘START”’,

20BTDC does engine speed fall to

IGN TIMING

IDLE POSITION

ON 650+ 50 rpm (A/T in ‘“‘N”’ posi- tion)? SEF727K OR S) Does engine run at 650+ 50 rpm (A/T in ‘‘N” position)? O.K. 6) ¥ N.G.

>| 1. Adjust output voltage by rotating throttle sen- SITION. S\

CHECK THROTTLE SENSOR IDLE PO-

1. Perform “THROTTLE SEN.

sor body. ADJ.” in “WORK SUPPORT”

2. Disconnect throttle Ca mode. sensor harness con-

2. Check that output voltage of nector for a few sec- SEF 1461 throttle sensor is approx. onds and then recon-

0.5+0.2V. (Throttle valve fully nect it.

LJ closes.) and “IDLE

@ THROTTLE SEN ADJ

3. Confirm that “IDLE POSITION” stays ‘‘ON’”’. POSITION” stays

* & & &ADJ MONITOR & * ¥*

OR Measure output voltage of throt-

THROTTLE SEN

0.44V tle sensor using voltmeter, and check that it is approx. 0.4 to

CAS-RPM (REF)

687rpm

0.5V. (Throttle valve fully ON closed.) O.K. SEF725K (Go to on next page.) o)

IDLE POSITION

4 CONNECT

‘O ®

5 —— SEF 1481

EF & EC-58

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.