Side Bearing Preload - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Side Bearing Preload - Nissan 240SX 1991-1992 Workshop Manual
Side Bearing Preload
ADJUSTMENT
For quiet and reliable final drive operation, the following five adjustments must be made correctly. > Side bearing preload Pinion gear height Pinion bearing preload Ring gear to pinion backlash (Refer to ASSEMBLY.) Ring and pinion gear tooth contact pattern arwn
Side Bearing Preload
A selection of carrier side bearing preload shims is required for successful completion of this procedure.
1. Make sure all parts are clean and that the bearings are well lubricated with hypoid gear oil.
2. Place the differential carrier, with side bearings and bearing races installed, into the final drive housing.
SPD919
3. Put the side bearing spacer in place on the ring gear end of the carrier.
ZSPD894
4. Using the J-25267 side bearing spacer drift, place both of the original carrier side bearing preload shims on the carrier end, opposite the ring gear.
SP D986 PD-18
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.