TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
‹ Prev TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop ManualNext › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES

TROUBLE DIAGNOSES
Electrical Components Inspection (Cont'd) *Data are reference values.
| TER- | |||
|---|---|---|---|
| MINAL | ITEM | CONDITION | *DATA |
| NO. | |||
| 19 | Exhaust gas sensor | [Engine is running.| | 0 - Approximately 1.0V |
| After warming up sufficiently | 0.3 - Approximately 5V | ||
| 20 | Throttle sensor | Ignition switch “ON” | Output voltage varies with the |
| throttle valve opening angle. | |||
| 22 30 | Crank angle sensor (Reference sig- nal) | [Engine is running,| Do not run engine at high speed | 0.1-1.3V |
| 30 | nal) | Do not run engine at high speed | |
| under no-load. | |||
| [Engine is running,| (Warm-up condi- | |||
| ti ion) | Approximately 0.7V | ||
| 25 | S.C.V. control solenoid valve | -Idle speed | |
| [Engine is running,| | |||
| -Engine speed is about 2,000 rpm. | BATTERY VOLTAGE (11 - 14V) | ||
| [Engine is running.| | |||
| 27 | Detonation sensor | “Idle speed | Approximately 2.5V |
| [Engine is running|| | |||
| 31 40 | Crank angle sensor (Position si | 9 (Position signal) | Do not run engine at high speed | 2.0 - 3.0V |
| under no-load. | |||
| | va? e ee 33 Ignition switch “ON” | Approximately OV | ||
| 34 | Start signal | — E-StaRT Ugnition switc | | BATTERY VOLTAGE (11 - 14V) |
| Ignition switch “ON” | |||
| 35 | Neutral switch | -Neutral | OV |
| 35 | Neutral switch | -Neutral Ignition switch “ON”! | |
| L-Except the above gear position | Approximately 6V | ||
| / iti . 6é Le] Ignition switch “OFF” | ov | ||
| 36 | Ignition switch | rw it h 6é oe) [gnition switch “ ON’) | BATTERY VOLTAGE (11 - 14V) |
| 37 | Throttle sensor power supply | | iti it oe 9 ['gnition switch “ON | | Approximately 5V |
| 38 47 | Power supply for E.C.U. | ~ : Ignition switch “ON” | , BATTERY VOLTAGE (11 - 14V) |
EF & EC-160
‹ Prev TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop ManualNext › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.