Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 29 (Cont’d)

fel Roap TEST

Perform FINAL CHECK by the following procedure after repair is completed. Test condition Drive vehicle under the following conditions with suitable shift position.

FINAL CHECK

Engine speed: (1) 2,400:800 rpm Intake manifold vacuum: (2) Vv —40.0+13.3 kPa Erase the self-diagnosis memory.

(—300+100 mmHg, —11.81+3.94 inHg)

Driving mode y . ® ® (@) : Test Perform test drive under the following Vehicle x condition conditions. driving |_______--- — @®:16 seconds 1) Warm up engine sufficiently. or more 2) Use test driving modes indicated in © :6 seconds y or more figure (ej.

Idling +/- --, @

Ignitio ? switch: ition @ © Comes ~ on. OFF Time v Make sure that check engine light does Recheck E.C.U. pin termi- Vv Until red L.E.D. goes off. not come on during test drive. nals for damage or the connection of E.C.U. har- Does not come on.

® Start engine and warm it up sufficiently.

ness connector. @ Turn off ignition switch and keep it off until red L.E.D. goes off. @) Start engine and make sure that air Vv conditioner switch and rear defogger are

INSPECTION END

turned “OFF’’ during test drive.

@ Keep engine running for at least 4 minutes.

(5) Shift to suitable gear position and drive in “Test condition” for at least 16 seconds. © Decrease engine revolutions to less than 1,500 rpm for at least 6 seconds.

@) Repeat steps 6) through ©) at lest 1 more

time. SEFOO7L LH]

CHECK

CHECK ENGINE LIGHT

SEF924F

EF & EC-113

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.