Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Control Valve Upper Body (Cont'd)

ASSEMBLY

Lubricate the control valve body and all valves with A.T.F.

1. Install control valves by sliding them carefully into their

SUN by

bores. @ Be careful not to scratch or damage valve body. fre i) _——< wih Zs oO Se = ww SN sTM) \ = ———i|| S a TN ‘Valve SAT830A

@ Wrap a small screwdriver with vinyl tape and use it to insert

the valves into proper position.

Pressure regulator valve If pressure regulator plug is not centered properly, sleeve @ [ cannot be inserted into bore in upper body. If this happens, use vinyl tape wrapped screwdriver to center sleeve until it can be inserted. CT. 7 Lightly push sleeve in while turning it. @ Turn sleeve slightly while installing.

Center plug in spool bore [A —

| ==) ) sates2a

Accumulator control plug

@ Align protrusion of accumulator control sleeve with notch in

plug.

@ Align parallel pin groove in plug with parallel pin, and install

accumulator control valve.

SAT833A Install parallel pins and retainer plates.

2.

SAT834A AT-129

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.