STARTING SYSTEM — Starter — - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › STARTING SYSTEM — Starter — - Nissan 240SX 1991-1992 Workshop Manual
STARTING SYSTEM — Starter —
STARTING SYSTEM — Starter —
Armature Check (Cont'd) Check diameter of commutator.
4. Commutator minimum diameter: Refer to S.D.S.
@ Less than specified value ... Replace.
ey Vernier caliper
Commutator SEL418A
5. Check depth of insulating mold from commutator surface.
e@ Less than 0.2 mm (0.008 in) ... Undercut to 0.5 to 0.8 mm
Undercut procedures (0.020 to 0.031 in) ———————
0.5 -0.8 mm (0.020 - 0.031 in) Round
Correct
File
Commutator Segment Mold
EE021 Incorrect Assembly
Apply high-temperature grease to lubricate the bearing, gears
and frictional surface when assembling the starter.
PINION PROTRUSION LENGTH ADJUSTMENT
Pinion stopper
With pinion driven out by magnetic switch, push pinion back to
Switch >So————_f5
remove slack and measure clearance ‘“Q’’ between the front
edge of the pinion and the pinion stopper. —————CiM , Clearance “Q”: ci Battery Refer to S.D.S.
. SEL299E Clearance ‘‘2”
EL-20
Parts & tools for this job For Nissan 240SX
- TOOLBattery testerSearch: car battery tester
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBattery terminal cleanerSearch: battery terminal cleaner
As an Amazon Associate we earn from qualifying purchases.