Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

SYSTEM DESCRIPTION — Push Control - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › SYSTEM DESCRIPTION — Push Control - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXSYSTEM DESCRIPTION — Push Control - Nissan 240SX 1991-1992 Workshop Manual

SYSTEM DESCRIPTION — Push Control

SYSTEM DESCRIPTION — Push Control

Intake Door Motor

IGNITION SWITCH

ACC or ON The intake door motor is installed on the front portion of the intake unit. Using a rod and link it opens and closes the intake Intake Intake door door door. motor motor When the REC switch is ON (OFF), the ground line of the intake connector door motor is switched from terminal () to @) (@ to (@)). This (LOT 9 1] causes the motor to start because the position switch contacts built into it are set to the current flow position. The contacts turn along with the motor. When they reach the non-current To push { flow position, the motor will stop. The motor always turns in the ntrol co RHA570C same direction.

Mode Door Motor

Mode door motor The mode door motor is located on the left side of the heater unit. connector Through the side link it opens and closes the vent, foot and [e] defroster door. (22761514 [3] 271 Px] 7 [8] When one mode switch is pushed, the position switch built into it *: Current flows as reads the corresponding mode to determine the direction of motor indicated by the To arrow, motor rotation. As soon as the desired mode is set, the position switch push < actuates as control stops the motor. indicated by ; the words. 22

Mode door motor Terminal No. Directi

Mode door

rec fon

@) operation

of linkage

p rotation S) Stop Stop ‘S) eS) @ |VENT->DEF | Clockwise Counter- clockwise iS) DEF>VENT © RHAS571C

Removal and Installation

| (ao 0 coco}

1. Remove cluster lid C. =

Cluster lid C \ J /

/ RHA3S84A

Remove audio (radio). WL Remove four screws of push control unit. = Push control assembly ui \ (E Remove temperature control cable. Disconnect push control unit harness connectors. Remove push control unit. ® NOOR . Installation is in the reverse order of removal. Refer to Control Linkage Adjustment for temperature control j@ cE cable. fo)

/ RHAS85A HA-98

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.