TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 3 — Unstable Idle
N.G.
CHECK E.G.R. CONTROL VALVE.
Repair or replace. Vv Check E.G.R. control valve for sticking. O.K. v No
Go to.
PERFORM POWER BALANCE TEST.
v
@ in “ACTIVE TEST” mode.
or
1. Perform ‘“POWER BALANCE’”’
2. Is there any cylinder which SEC547A does not produce a momen- tary engine speed drop?
MaActive test gw
L] OR <(=A\ When disconnecting each injec-
* & & POWER BALANCE ¥ ¥ ¥
e=6 tor harness connector one ata
CAS-RPM (REF)
712rpm time, is there any cylinder which
1.02V does not produce a momentary
AIR FLOW MTR
AAC VALVE
37% engine speed drop? Yes TEST LIL L_] START Vv No Check injector(s) and cir-
CHECK INJECTOR.
SEF729K
1. Remove distributor assembly from cuit(s). engine. (Crank angle sensor harness connector should remain connected.)
2. Disconnect ignition coil harness con- nector.
3. Turn ignition switch ON. (Do not start engine.)
4. When rotating crank angle sensor shaft, does each injector make an Fuel injector connector operating sound? ane // Yes SEF738K 4] v N.G.
CHECK IGNITION SPARK.
p| Check ignition coil, power
1. Disconnect ignition wire from rocker transistor unit and their circuits. (See page EF & cover.
2. Connect a known good spark plug to EC-114.) the ignition wire.
3. Place end of spark plug against a suitable ground and crank engine.
4. Check for spark. O.K. v SEF837K (Go to @ on next page.)
Ignition wire
4 Spark plug _ g i . SEF282G
EF & EC-61
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.