Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Liquid Gasket Application Procedure - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Liquid Gasket Application Procedure - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXLiquid Gasket Application Procedure - Nissan 240SX 1991-1992 Workshop Manual

Liquid Gasket Application Procedure

PRECAUTIONS

Parts Requiring Angular Tightening Some important engine parts are tightened using an angular-tightening method rather than a torque setting method. If these parts are tightened using a torque setting method, dispersal of the tightening force (axial bolt force) will be two or three times that of the dispersal produced by using the correct angular tightening method. Although the torque setting values (described in this man- ual) are equivalent to those used when bolts and nuts are tightened with an angular-tightening method, they should be used for reference only. To assure the satisfactory maintenance of the engine, bolts and nuts must be tightened using an angular tightening method. Before tightening the bolts and nuts, ensure that the thread and seating surfaces are clean and then coated with engine oil. The bolts and nuts which require the angular-tightening method are as follows: (1) Cylinder head bolts (2) Connecting rod cap nuts.

Liquid Gasket Application Procedure

Before applying liquid gasket, use a scraper to remove all traces of old liquid gasket from mating surface.

b. Apply a continuous bead of liquid gasket to mating sur- faces. (Use Genuine Liquid Gasket or equivalent.) e Be sure liquid gasket is 3.5 to 4.5 mm (0.138 to 0.177 in) wide (for oil pan). Groove e Be sure liquid gasket is 2.0 to 3.0 mm (0.079 to 0.118 in) Bolt hole wide (in areas except oil pan). Apply liquid gasket to inner surface around hole perimeter SEM371C area. (Assembly should be done within 5 minutes after coating.) Wait at least 30 minutes before refilling engine oil and engine coolant.

EM-2

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.