TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 45 (Cont’d)
A/T control unit
% MONITOR xNO FAIL [_]
START SIGNAL
OFF
INSPECTION START
IDLE POSITION
ON
AIR COND SIG
OFF D) y
NEUTRAL SW
ON O.K.
CHECK OVERALL FUNCTION.
INSPECTION END
Vv 1) Turn ignition switch a RECORD | 2) Check neutral switch signal in “DATA SEF385J/ MONITOR” mode with CONSULT.
|[_camrt (of ommeorat
Ee cen”? or “<p. ON Except above: OFF OR [| 1) Make sure that inhibitor
0:6 switch circuit functions
(25
properly. (Refer to AT
section.) 2) Disconnect E.C.U. har- ness connector. 3) Shift selector lever to MEF725A “P” range. 4 €) 4) Turn ignition switch
| c~nrT Elsovecrar]
e) 5) Check harness continu- ity between E.C.U. ter- minal @5) and body
|L_cvnrt_[e| connector
]| ground. 13 A/T Continuity should exist. CONTROL @) 6) Shift selector lever to [a] UNIT “N” range. +e 7) Check harness continu- MEF726A ity between E.C.U. ter- minal 65) and body ground. Continuity should exist. N.G. Vv N.G.
CHECK INPUT SIGNAL CIRCUIT.
> Check the following. e Harness connectors(9), 1) Turn ignition switch “‘OFF’’. e Harness continuity between 2) Disconnect A/T control unit harness connector. E.C.U. and A/T control unit 3) Check harness continuity be- If N.G., repair harness or con- tween E.C.U. terminal @5) and nectors. terminal @. Continuity should exist. O.K. Vv Check E.C.U. pin terminals for damage or the connection of E.C.U. harness connector.
EF & EC-177
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.