Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 29 (Cont’d)

Perform FINAL CHECK by the following procedure after repair

ROAD TEST

is completed. Test condition

Drive vehicle under the following conditions

with suitable shift position.

FINAL CHECK

Engine speed: (1) 2,400: 800 rpm Vv Intake manifold vacuum: (2) Erase the self-diagnosis mem- —40.0+13.3 kPa

(—300+100 mmHg, —11.81+3.94 inHg)

ory.

Driving mode

y | Perform test drive under the fol- 8 8 @®:Test Vehicle lowing conditions. condition driving |.____.---- ® : 16 seconds 1) Warm up engine sufficiently. or more 2) Use test driving modes indi- ‘© :6 seconds cated in figure @. y or more

Idling +/- --, @

Comes Ignition ; switch: @ © _ iti ¥ on. Make sure that check engine Recheck E.C.U. pin terminals for Vv OFF Time damage or the connection of light does not come on during E.C.U. harness connector. Until red L.E.D. goes off. test drive. Does not come on. X

® Start engine and warm it up sufficiently.

@) Turn off ignition switch and keep it off

INSPECTION END

until red L.E.D. goes off. Start engine and make sure that air conditioner switch and rear defogger are turned “OFF” during test drive.

@ Keep engine running for at least 4 minutes.

(5) Shift to suitable gear position and drive in “Test condition” for at least 16 seconds. © Decrease engine revolutions to less than 1,500 rpm for at least 6 seconds.

@) Repeat steps G) through © at lest 1 more

time. SEFOO7L [Hi

CHECK

CHECK ENGINE LIGHT

SEF924F

EF & EC-123

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.