WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual
WINDSHIELD AND WINDOWS
WINDSHIELD AND WINDOWS
Back Window—Coupe
Construction and removal/reinstallation methods of back window are basically the same as those of windshield. For details of service procedures, refer to ‘‘Windshield”’. The difference between windshield and back window is as follows: For sealant drying period, refer to ‘‘Drying Time for Sealant’’. For details of moldings, refer to “Exterior”.
Sealant quantity Pq
Molding fastener
Spacer [3]
Dam rubber and spacer [s)
Ic] Install molding fastener. Vehicle BI When installing it, heat body panel and | center fastener to approx. 30 to 40°C (86 to More than Double-faced 30 12 (0.47) 104°F). adhesive tape P Dam rubber (1.18) P =, Fastener A Fastener A S! Body panel 4201 J (16.54) Panel Double-faced More than adhesive tape Double-faced .
Vel Fastener B|
7 (0.28) adhesive tape Unit: mm (in) _J Unit: mm (in)
DI Install dam rubber and spacers with
Upper and side portion
Lower portion Dam rubber double-faced adhesive tape. (Body side) Vehicle a center | 3 Spacer
| Body panel wy Double-faced
Z Dam rubber
qf: Spacer Dam rubber adhesive tape Double-faced mounting adhesive tape joint portion portion
SBF200E BF-74
Parts & tools for this job For Nissan 240SX
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Nissan touch up paint
- PARTPanel clip assortmentSearch: Nissan panel clips assortment
As an Amazon Associate we earn from qualifying purchases.