Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

BRAKE PEDAL AND BRACKET - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › BRAKE PEDAL AND BRACKET - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXBRAKE PEDAL AND BRACKET - Nissan 240SX 1991-1992 Workshop Manual

BRAKE PEDAL AND BRACKET

BRAKE PEDAL AND BRACKET

Adjustment Check brake pedal free height from dash reinforcement panel. Lock nut Adjust if necessary.

Input rod \ (0) 16 - 22 (1.6 - 2.2, 12 - 16)

H: Free height Refer to S.D.S. D: Depressed height Refer to S.D.S. Under force of 490 N (50 kg, 110 Ib) with engine running Stop lamp switch C:: Clearance between pedal stopper and threaded Gand A.S.C.D. switch end of stop lamp switch 12 - 15

0.3 - 1.0 mm (0.012 - 0.039 in) (1.2 - 1.5, 9 - 11) C2: Clearance between pedal stopper and threaded end of A.S.C.D. switch

0.3 - 1.0 mm (0.012 - 0.039 in) A: Pedal free play 9 Floor carpet Floor carpet 1 - 3 mm (0.04 - 0.12 in)

Dash rao

“

/ Dash insulator

Floor panel = an Melt sheet (O) : Nem (kg-m, ft-lb) SBR153A

1. Adjust pedal free height with brake booster input rod. Then tighten lock nut. wg-——Stays inside Make sure that tip of input rod stays inside. ———= LJ] i Input rod Clevis pin Lock nut SBR930

2. Adjust clearance ‘‘C,”’ and ‘C2’ with stop lamp switch and A.S.C.D. switch respectively. Then tighten lock nuts.

3. Check pedal free play. Make sure that stop lamp is off when pedal is released.

4. Check brake pedal’s depressed height while engine is running. If depressed height is below specified value, check brake system for leaks, accumulation of air or any damage to components (master cylinder, wheel cylinder, etc.); then make necessary repairs.

BR-7

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.