TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 15 — Engine Stalls when
Bactivetest mg
LL]
Accelerating or when Driving at Constant Speed
* & & POWER BALANCE ¥ ¥ ¥
No Go to £¥.
PERFORM POWER BALANCE TEST.
CAS-RPM (REF)
712rpm i~ |
1.02V cm \ 1. Perform ‘‘POWER BALANCE” 37%
AIR FLOW MTR
AAC VALVE
in “ACTIVE TEST” mode.
2. Is there any cylinder which | En does not produce a momen- TEST
L ILOL IL
START tary engine speed drop? OR SEF729K
(Ey When disconnecting each injec-
(bf | tor harness connector one ata
ita = DISCONNECT time, is there any cylinder which does not produce a momentary engine speed drop? | Yes
No Check injector(s) and cir-
CHECK INJECTOR.
cuit(s).
1. Remove distributor assembly from Fuel injector connector ame al engine. (Crank angle sensor harness connector should remain connected.) SEF738K
2. Disconnect ignition coil harness con- nector.
3. Turn ignition switch ON. (Do not start engine.)
4. When rotating crank angle sensor shaft, does each injector make an operating sound? Yes Vv N.G.
CHECK IGNITION SPARK.
»| Check ignition coil, power
1. Disconnect ignition wire from rocker transistor unit and cir- SEF837K cuits. (See page EF & cover. EC-114.)
2. Connect a known good spark plug to the ignition wire. Ignition wire
3. Place end of spark plug against a suitable ground and crank engine.
4. Check for spark. | OK.
(Go to @ on next page.) Spark plug
SEF282G
EF & EC-85
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.