Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CHECK AND ADJUSTMENT — On-vehicle - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CHECK AND ADJUSTMENT — On-vehicle - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCHECK AND ADJUSTMENT — On-vehicle - Nissan 240SX 1991-1992 Workshop Manual

CHECK AND ADJUSTMENT — On-vehicle

CHECK AND ADJUSTMENT — On-vehicle

Rear Wheel Bearing @ Check that wheel bearings operates smoothly. @ Check axial end play. | Axial end play:

0.05 mm (0.0020 in) or less If axial end play is not within specification or wheel bearing does not turn smoothly, replace wheel bearing assembly. Refer to REAR AXLE — Wheel Hub and Axle Housing.

SRA107A Rear Wheel Alignment

Before checking rear wheel alignment, be sure to make a

preliminary inspection.

PRELIMINARY INSPECTION

Make following checks. Adjust, repair or replace if necessary.

@ Check tires for wear and for improper inflation.

@ Check rear wheel bearings for looseness. Inside Check wheel runout. @ Refer to S.D.S. Wi

@ Check that rear shock absorber works properly.

@ Check rear axle and rear suspension parts for looseness.

SFA575B @ Check vehicle posture (Unladen). “Unladen”:

Fuel tank, radiator and engine oil full. Spare tire, jack, hand

tools and mats in designated positions.

CAMBER

Measure camber of both right and left wheels with a suitable

alignment gauge and adjust in accordance with the following

Attachment procedures. Alignment gauge

SRAOQ6A Camber: -1°36’ to -0°36’ Cambar

0°

SRAO97TA RA-6

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.