Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual

REAR AXLE — Drive Shaft

REAR AXLE — Drive Shaft

Assembly (Cont'd)

7. Lock new larger boot band securely with a suitable tool, then lock new smaller boot band.

“~~ SFA472

WHEEL SIDE

Install new small boot band and boot on drive shaft.

1.

Cover drive shaft serration with tape to prevent damage to

boot during installation. = Tape SS

SFA800

2. Install spider assembly securely, making sure marks are prop- erly aligned. Press-fit with spider assembly serration chamfer facing shaft.

3. Install new snap ring. ie *e Suitable tool

Chamfer SFA397

4. Pack drive shaft with specified amount of grease. f : " Specified amount of grease: 145 - 155 g (5.11 - 5.47 oz)

5. Install slide joint housing, then install new snap ring “‘A”’.

6. Set boot so that it does not swell and deform when its length is ‘‘L2”. Length “L.”: | { q T I 110.5 - 112.5 mm (4.35 - 4.43 in) Make sure that boot is properly installed on the drive shaft groove. SRA125A Lock new larger and smaller boot bands securely with a

7. suitable tool.

Boot band SFA395

RA-18

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.