Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXWINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual

WINDSHIELD AND WINDOWS

WINDSHIELD AND WINDOWS

Back Door Window— Fastback e Construction and removal/reinstallation method of back door window are basically the same as those of windshield. e Major differences are that sealant & dam rubber are installed to back door panel instead of glass surface. Spacer position is also changed. Moreover, there are locating pins in lower portion of glass. For details, refer to following figure. For sealant drying period: refer to ‘‘Drying Time for Sealant”. e@ For details of moldings, refer to ‘’Exterior”’.

Sealant portion

Locating pin (Left and right)

Sealant portion [B)

xx : Spacer — Lower molding e: Locating pin and spacer BI ©: Molding clip Sealant portion

Locating pin

iB

When installing it, heat body

iC Molding fastener C . . Back door upper molding (Bonded on panel & fastener to approx. More glass surface) 30 to 40°C (86 to 104°F). Back door glass than 12 (0.47)

More than 7 (0.28) Double-faced Welt

adhesive tape

Back door panel Back door glass Sealant Unit: mm (in) [s)

Back door side

door glass

oe molding 12 (0.47)

Back door glass

p<

More than

12 (0.47) B More than 7 (0.28)

Back door panel More than (0.28)

Back door panel

(0. 7 Unit: mm (in) Unit: mm (in) SBF201E BF-75

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.