TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 14 — Engine Stalls after Decelerating (Cont'd)
!
LL]
Mactivetest gw
PERFORM POWER BALANCE TEST.
No Go to fq.
% & & POWER BALANCE * * *
=
1. Perform ‘‘“POWER BALANCE”
CAS-RPM (REF)
712rpm in “ACTIVE TEST” mode.
AIR FLOW MTR
1.02V
37%
AAC VALVE
2. Is there any cylinder which does not produce a momen-’ | tary engine speed drop? TEST OR
LIL LL
START (Ey When disconnecting each injec-
(he tor harness connector one at a
SEF729K = time, is there any cylinder which IASY, does not produce a momentary engine speed drop? Yes 4 v No
Check injector(s) and cir- Vv
CHECK INJECTOR.
1. Remove distributor assembly from cuit(s). engine. (Crank angle sensor harness
Fuel injector connector
connector should remain connected.)
2. Disconnect ignition coil harness con- SEF738K nector.
3. Turn ignition switch ON. (Do not start engine.)
4. When rotating crank angle sensor shaft, does each injector make an operating sound? Yes : N.G.
,| Check ignition coil, power transistor unit and cir-
CHECK IGNITION SPARK.
1. Disconnect ignition wire from rocker cuits. (See page EF & cover.
2. Connect a known good spark plug to EC-114.) SEF837K the ignition wire.
3. Place end of spark plug against a Ignition wire suitable ground and crank engine.
4. Check for spark. | OK.
(Go to on next page.) Spark plug
SEF282G
EF & EC-82
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.