Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 1

i —* Tats {

S SYMPTOM: O.D. OFF indicator lamp does not come on 4 9 CONNECT for about 2 seconds when turning ignition switch to ‘‘ON’’. G/L G/L 1 N.G.

CANIT (> CONNECTOR ||

CHECK A/T CONTROL

Check the following items. is ~ i~

UNIT POWER SOURCE.

@ Harness continuity between

1. ignition switch and A/T con- trol unit = SAT997B Sa @ Ignition switch and fuse — Refer to section EL.

IL C/AUNIT {el CONNECTOR

4

2. Check voltage between A/T

control unit terminals @), @) and ground. Battery voltage should exist. Lor

CHECK A/T CONTROL UNIT

|“-S: Check harness continuity

GROUND CIRCUIT.

between A/T control unit and ground. SAT998B

2. Disconnect A/T control unit

connector. Fuse a Ignition switch tS

3. Check resistance between A/T

control unit terminals (5 ,

O.D. OFF

© indicator

and ground. Resistance: lamp Approximately 00 O.K. 4 3 A/T control unit +

CHECK LAMP CIRCUIT.

N.G. Check the following items. Vv @ O.D. OFF indicator lamp

[C/UNIT [0] CONNECTOR

| vets — Refer to section EL.

3. 4 TS. @ Harness continuity between DISCONNECT ignition switch and O.D. OFF

2. Disconnect A/T control unit €. GR G/L idicator lamp connector. (Main harness)

3. Check resistance between @ Harness continuity between A/T control unit terminals (3) and (4). O.D. OFF indicator lamp and ~) o Resistance: 50 - 10002 A/T control unit

4. Reinstall! any part removed. SAT738D O.K. Vv N.G. —»

1. Perform A/T control unit Check again. input/output signal inspection. yok

2. If N.G., recheck A/T control y unit pin terminals for damage

INSPECTION END

or connection of A/T control unit harness connector.

AT-60

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.