Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

Valve Clearance CHECKING Check valve clearance while engine is warm but not running.

1. Remove rocker cover and all spark plugs.

2. Set No. 1 cylinder at T.D.C. on its compression stroke. e Align pointer with T.D.C. mark on crankshaft pulley. e Check that valve lifters on No. 1 cylinder are loose and valve lifters on No. 4 are tight. If not, turn crankshaft one revolution (360°) and align as above. SEM261D

3. Check only those valves shown in the figure.

ti oe

SEM374D} e Using a feeler gauge, measure clearance between valve lifter and camshaft. e@ Record any valve clearance measurements which are out of specification. They will be used later to determine the required replacement adjusting shim. Valve clearance (Hot): Vy; Intake

SS Was

A gs =

0.31 - 0.39 mm (0.012 - 0.015 in) Exhaust

0.33 - 0.41 mm (0.013 - 0.016 in)

st adap

4. Turn crankshaft one revolution (360°) and align mark on crankshaft pulley with pointer. TM Engine front

5. Check those valves shown in the figure. e Use the same procedure as mentioned in step 4.

6. If all valve clearances are within specification, install the THEY

TPO LSS

een Sol Aisi

Deeet ieee # vo

following parts. @ Rocker cover e All spark plugs

ADJUSTING Adjust valve clearance while engine is cold.

1. Turn crankshaft, to position cam lobe on camshaft of valve that must be adjusted upward.

2. Place Tool (A) around camshaft as shown in figure.

3. Rotate Tool (A) so that lifter is pushed down. Before placing Tool (A), rotate notch toward center of cylinder head (See figure.), to simplify shim removal later.

CAUTION: Be careful not to damage cam surface with Tool (A). SEM305D EM-29

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.