TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 31 (Cont'd)
4 €&) DISCONNECT yr. A €> OISCONNECT
INSPECTION START
CANIT Ht CONNECTOR 2
& y N.G.
CHECK INPUT SIGNAL CIRCUIT.
Repair harness or connectors. Si 1) Disconnect E.C.U. harness connector and detonation sensor sub-harness connec- tor. 2) Check harness continuity be- tween terminal () and E.C.U. MEF698A terminal @). Continuity should exist. O.K. Vv N.G. ,| Replace detonation sensor.
CHECK COMPONENT
| (Detonation sensor). Refer to “Electrical Components Inspection’. (See page EF & EC-187.) O.K. ‘ Check E.C.U. pin terminals for damage or the connection of E.C.U. harness connector.
Perform FINAL CHECK by the following procedure after repair is completed.
FINAL CHECK
Vv Erase the self-diagnosis mem- ory. ' Perform test drive.
Vv N.G. Perform self-diagnosis again. Recheck E.C.U. pin terminals for damage or the connection of O.K. E.C.U. harness connector.
Vv
INSPECTION END
EF & EC-131
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.