Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TIME CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TIME CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTIME CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

TIME CONTROL SYSTEM

TIME CONTROL SYSTEM

Trouble-shooting

SymptomDIAGNOSTIC
PROCEDURE
Intermittent wiper does not operate.1
Wiper & washerIntermittent time of wiper cannot be adjusted.2
Wiper and washer activate individually but not in combination3
IluminationIIlumination control system does not actuate.4
Light warning chime does not activate.5
WarningSeat belt warning chime does not activate.6
WarningSeat belt warning lamp does not go off nor come on.7
Ignition key warning chime does not activate.8
Rear defoggerRear defogger does not activate, or does not go off.9

PREPARATION FOR TROUBLE-SHOOTING

(| . oy, ; 1]2]314]516] 71819 f0]| | Ga

1. Remove driver’s side dash side cover. 11]12/13h14]isfiep<] 1819

2. Remove time control unit with harness connected.

POWER SUPPLY CIRCUIT CHECK

1. Connect ohmmeter from harness side.

2. Check continuity between terminal (5 and body ground.

oC t > SEL689L

Ohmmeter terminals
(+) (-)Continuity
5) Body groundYes

——___JZL 1]2]3]4]5]6l7[sfofol| | Ga Mii2hah4hshebcheho

3. Connect voltmeter from harness side.

4. Measure voltage across terminal 45) and terminals (2), © or

Voltmeter terminalsIgnition switch position
(+) (—)OFF ACC ON
(9) (5)Approx. 12V | Approx. 12V | Approx. 12V
6) (5)OV OV Approx. 12V
@) (5)OV Approx. 12V_ | Approx. 12V

‘ OO SELGOOL

EL-67

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.