Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 9 1 | 0/0

O ofr

SYMPTOM: A/T does not shift from D; to D. at the

specified speed. . Self-diagnosis A/T does not shift from D. to D. when start depressing accelerator pedal fully at the specified speed. Pt Light Are Diagnostic Procedures 7 and No | Go to Diagnostic Procedure 7 or

8. 8 O.K.? ——-- Shade SAT157C Yes v Yes | Check inhibitor switch circuit. Does “E.C.U. INPUT — Refer to ‘‘Self-diagnosis”’. SIGNALS” show damage “| Electric “C) speedometer to inhibitor switch circuit? Revolution Speed sensor OR Does self-diagnosis show <=P\ Cb ) . “pe : c=y/ damage to inhibitor switch 25 35 27 circuit? A/T control unit SAT980D No y

N.G. | Repair or replace revolution

Check revolution sensor and

fe })))), sensor and speed sensor circuits. speed sensor circuit. — Refer to “| throttle valve switch “Y ), “‘Self-diagnosis’’. ( O.K. N/ t N.G. ; Check throttle sensor. — Refer +| Repair or replace throttle sensor. to section EF & EC. Fat XA O.K. 4 | v .

Throttle sensor and 7 Hy

1. Remove oil pan. N.G.

2. Check A/T fluid condition. "| | 1. Remove control valve. — — gi Refer to ‘““ON-VEHICLE O.K. ‘| SERVICE”. "|

2. Check the following items. @ Shift valve A @ Shift solenoid A O.K. @ Pilot valve , O-K. |] © Pilot filter

3. Disassemble A/T.

4. Check the following items. @ Servo piston assembly @ Brake band savi7i8 @ Oil pump assembly 8/8 2 |sy/8= x N.G

Dirt D2 @

7 . . Depress Check again. p>!

1. Perform A/T control unit fy input/output signal inspection.

2. If N.G., recheck A/T control

|o*

“+ Release

{D ) © unit pin terminals for damage D LD or connection of A/T control

INSPECTION END

a 3

unit harness connector.

—i [0/8 0/8 SAT118B {Dd AT-67

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.