Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Assembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Assembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXAssembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Assembly (Cont'd)

ASSEMBLY

Assembly (Cont'd)

f. Install clutch pack into transmission case.

Wooden block

SAT220B

4. Install brake band and band strut.

a. Install band strut on brake band. @ Apply petroleum jelly to band strut.

b. Place brake band on periphery of reverse clutch drum, and insert band strut into end of band servo piston stem.

Install anchor end bolt on transmission case. Then, tighten

c.

anchor end bolt just enough so that reverse clutch drum

(clutch pack) will not tilt forward.

5. Install input shaft on transmission case. @ Pay attention to its direction — O-ring groove side is front.

6. Install gasket on transmission case.

SAT98B8A AT-178

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.