Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ON-VEHICLE SERVICE (Final drive) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ON-VEHICLE SERVICE (Final drive) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXON-VEHICLE SERVICE (Final drive) - Nissan 240SX 1991-1992 Workshop Manual

ON-VEHICLE SERVICE (Final drive)

ON-VEHICLE SERVICE (Final drive)

Front Oil Seal Replacement

1. Remove propeller shaft.

2. Loosen drive pinion nut with Tool. Tool number: ST38060002 (J34311)

3. Remove companion flange.

4. Remove front oil seal.

5. Apply multi-purpose grease to sealing lips of oil seal. Press front oil seal into carrier. Install companion flange and drive pinion nut. NO Install propeller shaft.

Side Oil Seal Replacement

1. Remove drive shafts. Refer to RA section.

2. Remove oil seal.

PD-9

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.