Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 6 — Hard to Start or

Impossible to Start under Normal Conditions

N.G. »

CHECK BATTERY AND STARTER.

Repair or replace. a Check battery and starter operation. (Refer to EL section.) O.K. Vv

Check fuel pump and cir-

No

CHECK FUEL PRESSURE.

SEF380!'

1. Pinch fuel feed hose with fingers. cuit. (See page EF &

2. When cranking the engine, is there EC-138.) any pressure on the fuel feed hose? Yes Vv Yes

Check injector(s) for leak- When pressing accelerator pedal fully, age. can you start the engine. No 4) y No v

CHECK INJECTOR FOR LEAKAGE.

CHECK INJECTOR.

Check injectors and cir- 52 =] ce] =] as Cc @ @ Qa zs ° a @ —~ => sy ~ SEF740K Vv

2. @

1. Remove crank angle sensor from

cuits.

engine. (Crank angle sensor harness

connector should remain connected.)

2. Disconnect ignition coil harness con-

nector.

3. Turn ignition switch ON. (Do not start

engine.)

4. When rotating crank angle sensor

shaft, does each injector make an

operating sound? Yes SEF 1441 Vv N.G. p| Check ignition coil, power

CHECK IGNITION SPARK.

1. Disconnect ignition wire from rocker transistor unit and cir- cuits. (See page EF & cover.

2. Connect a known good spark plug to EC-107.) the ignition wire.

3. Place end of spark plug. against a suitable ground and crank engine.

4. Check for spark. O.K. v SEF837K (Go to ®@ on next page.)

Ignition wire

Spark plug

SEF282G

EF & EC-68

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.