REAR DISC BRAKE (CL9H) — Caliper - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REAR DISC BRAKE (CL9H) — Caliper - Nissan 240SX 1991-1992 Workshop Manual
REAR DISC BRAKE (CL9H) — Caliper
REAR DISC BRAKE (CL9H) — Caliper
Assembly (Cont'd)
@ Install ring C with suitable tool. Ring C~ Key plate —_ca
Push rod
SBR878 @ Install seat, spring, spring cover and ring B with suitable press and drift.
SBR492A
Inspection (On-vehicle)
INSPECTION OF BRAKE DRAG FORCE
1. Swing cylinder body upward.
2. Make sure that wheel bearing is adjusted properly. Refer to section RA.
3. Measure rotating force (F;).
Install caliper with pads to original position. Depress brake pedal for 5 seconds. Release brake pedal, rotate disc rotor 10 revolutions. Measure rotating force (Fz). ONOAS Calculate brake drag force by subtracting F; from Fe. Maximum brake drag force (F2 — F:):
86.3 N (8.8 kg, 19.4 Ib) If it is not within specification, check pins and pin boots in Caliper.
SBR486A
DISC PAD
Check disc pad for wear or damage. Standard thickness (A):
9.5 mm (0.374 in) Pad wear limit (A):
1.5 mm (0.059 in)
SMA364A BR-21
Parts & tools for this job For Nissan 240SX
- PARTRear brake padsSearch: Nissan 240SX rear brake pads
- TOOLCaliper piston rewind toolSearch: brake caliper piston rewind tool
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.