Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 9 — Hesitation under

1

Normal Conditions

1 | N.G.

Repair or replace spark Remove spark plugs and check for plug(s). fouling, etc. O.K. y Yes

CHECK SPARK PLUGS.

p| Replace exhaust gas sen- oN

CHECK EXHAUST GAS SENSOR.

1. See “M/R F/C MNT” in sor(s). SEF879J “DATA MONITOR” mode.

2. Maintaining engine at 2,000

YMONITOR WNO FAIL []

rpm under no-load (with en-

— 2000rpm gine warmed up sufficiently.),

CAS-RPM (REF)

M/R F/C MNT

RICH check to make sure that the monitor fluctuates between “LEAN” and “RICH” more than 5 times during 10 sec- onds. | RECORD

RICH—LEAN >RICH—

1 time 2 times SEF722K LEAN—RICH....... OR

1. Set “Exhaust gas sensor monitor’’ in the self-diagnostic Mode II. (See page EF & EC-

44.)

2. Maintaining engine at 2,000 rpm under no load, check that check engine light or RED LED on the E.C.U. goes ON Check engine light and OFF more than 5 times

RED L.E.D

during 10 seconds. SEF621K No

c Nacuum line

Vv Yes ,| Check purge and vacuum

SIT KR /

CHECK CANISTER PURGE.

Purge line [

1. Disconnect canister purge line hose lines. Vapor line and plug hose. —= Ye >

2. Perform cruise test.

3. Does the hesitation disappear? No 4 Vv

Discover air leak location

CHECK FOR INTAKE AIR LEAK.

Yes Carbon canister - Vv When pinching blow-by hose (lowering and repair. SEF750K the blow-by air supply), does the en- gine speed rise? No Vv

INSPECTION END

SEF300G

EF & EC-71

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.