TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 13 — Engine Stalls when Stepping on the Accelerator
Momentarily (Cont'd)
a l Ignition wire N.G. || Check ignition coil, power
CHECK IGNITION SPARK.
1. Disconnect ignition wire from rocker transistor unit and their circuits. (See page EF & cover.
2. Connect a known good spark plug to EC-114.) the ignition wire. Spark plug
3. Place end of spark plug against an earth point with engine cranking.
4. Check for spark. SEF282G O.K. Vv Mi FUEL PRES RELEASE N.G.
|| Check fuel pressure reg-
CHECK FUEL PRESSURE.
id ulator diaphragm.
—~
1. Perform ‘FUEL PRESSURE
FUEL PUMP WILL STOP BY
RELEASE” in ‘“‘WORK
TOUCHING START IN IDLING.
CRANK A FEW TIMES AFTER
SUPPORT” mode in order to
ENGINE STALL.
release fuel pressure to zero.
2. Install fuel pressure gauge and check fuel pressure. A few seconds after ignition L START | switch is turned OFF to ON: Approx. 4 294 kPa (3.0 kg/cm?, 43 psi) At idle: Approx. 235 kPa (2.4 kg/cm?, 34 psi) OR (=p 1. Release fuel pressure to zero.
8:6 (Refer to page EF & EC-191.)
Ce” 2. Install fuel pressure gauge
and check fuel pressure. O.K.
serail fj
v N.G.,) Repair or replace.
CHECK E.C.U. HARNESS CONNECTOR.
Check the E.C.U. pin terminals for dam- age or poor connection of E.C.U. har- ness connector. O.K. v
N.G. | Repair or replace.
CHECK E.C.U. POWER SUPPLY AND
GROUND CIRCUIT.
Refer to page EF & EC-96. O.K.
8. Vv
TRY A KNOWN GOOD E.C.U.*
Vv
INSPECTION END
*: E.C.U. may be the cause of a problem, but this is rarely the case.
EF & EC-80
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.