BODY ALIGNMENT - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › BODY ALIGNMENT - Nissan 240SX 1991-1992 Workshop Manual
BODY ALIGNMENT
BODY ALIGNMENT
e All dimensions indicated in figures are actual ones. When a tram tracking gauge is used, adjust both pointers to equal length and check the pointers and gauge itself to make sure there is no free play. When a measuring tape is used, check to be sure there is no elongation, twisting or bending. e Measurements should be taken at the center of the mounting holes. e Anasterisk (*) following the value at the measuring point indicates that the measuring point on the other side is symmetrically the same value. e The coordinates of the measurement points are the distances measured from the standard line of “X”, ayer and 7". “yy on “XK oo ADS. @ CR) an l ==—I1 > 4}8 _— == J “a
amp (+) “xX” + Vehicle center “y “Y" : Center line of front axle “Z" + Imaginary base line (CH) : L.H. side [200 mm below datum line : R.H. side (“OZ" at design plan)]
Engine Compartment
MEASUREMENT
Unit: mm SBF193E
Parts & tools for this job For Nissan 240SX
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Nissan power steering fluid
As an Amazon Associate we earn from qualifying purchases.