Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

INSPECTION AND ADJUSTMENT - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › INSPECTION AND ADJUSTMENT - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXINSPECTION AND ADJUSTMENT - Nissan 240SX 1991-1992 Workshop Manual

INSPECTION AND ADJUSTMENT

INSPECTION AND ADJUSTMENT

Adjusting Clutch Pedal

1. Adjust pedal height with pedal stopper or A.S.C.D. cancel Pedal bracket switch. Pedal height “H”’: 186 - 196 mm (7.32 - 7.72 in)

2. Adjust pedal free play with master cylinder push rod. Then A.S.C.D. cancel switch tighten lock nut. pedal stopper lock nut Lock nut or Pedal free play “A”: @ A.S.C.D. cancel switch ()s-11

1.0 - 3.0 mm (0.039 - 0.118 in) ) 12-15 (1.2 -1.5,9 - 11) (0.8 - 1.1, 5.8 - 8.0 e Pedal stopper Pedal free play means the following total measured at position of 16 -22 516 -2.2, 12 - 16) pedal pad: @ Play due to clevis pin and clevis pin hole in clutch pedal.

3. Make sure that clevis pin can be rotated smoothly. If not, readjust pedal free play with master cylinder push rod. Dash lower panel

O : N-m (kg-m, ft-lb) SCL323 — U.S.A. model only —

3. Adjust clearance ‘‘C” between pedal stopper rubber and threaded end of clutch interlock switch while depressing clutch pedal fully. Clearance C:

1.0 - 2.0 mm (0.039 - 0.079 in)

Clutch interlock switch

Clutch interlock switch Lock nut utch interlock Thread of cl switch

SCL433

CL-5

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.