Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

PRECAUTIONS AND PREPARATION - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › PRECAUTIONS AND PREPARATION - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXPRECAUTIONS AND PREPARATION - Nissan 240SX 1991-1992 Workshop Manual

PRECAUTIONS AND PREPARATION

PRECAUTIONS AND PREPARATION

Precautions @ When installing each rubber part, final tightening must be carried out under unladen condition* with tires on ground. * Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. @ When removing each suspension part, check wheel alignment and adjust if necessary. @ Use Tool when removing or installing brake tubes.

SBR500

Preparation

SPECIAL SERVICE TOOLS

Tool number Description (Kent-Moore No.) Tool name HT72520000 Removing tie-rod outer end and lower (J25730-A) ball joint Ball joint remover

HT7 1780000 Removing and installing coil spring ( - ) Spring compressor

$T35652000 Fixing strut assembly - ) ( Strut attachment

GG94310000 Removing and installing brake piping - ) ( - Flare nut torque wrench

FA-2

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.