CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
Valve Clearance (Cont'd)
4. Place Tool (B) between camshaft and valve lifter to retain valve lifter.
CAUTION: e Tool (B) must be placed as close to camshaft bracket as possible. e Be careful not to damage cam surface with Tool (B).
5. Remove Tool (A).
6. Remove adjusting shim using a small screwdriver and a <> Tool (B) Rf \ ae magnetic finger.
7. Determine replacement adjusting shim size following for- mula. e Using a micrometer determine thickness of removed shim. e Calculate thickness of new adjusting shim so valve clear- ance comes within specified values. R = Thickness of removed shim | Thickness of new shim Zz M = Measured valve clearance Intake: N = R + [M— 0.35 mm (0.0138 in)] Exhaust: N = R + [M — 0.37 mm (0.0146 in)] SEM145D ‘Shims are available in 37 sizes from 1.96 mm (0.0772 in) to 2.68 mm (0.1055 in), in steps of 0.02 mm (0.0008 in). Select new shim with thickness as close as possible to calculated value. ? 2 4 = 2.24 mm yA (0.0882 in)
Thickness is stamped.
SEM308D Install new shim using a suitable tool. BEB \X Install with the surface on which the thickness is stamped ese facing down. > Place Tool (A) as mentioned in steps 2 and 3.
10. Remove Tool (B).
11. Remove Tool (A). CO
12. Recheck valve clearance. Refer to “CHECKING”. (i SEM309D EM-30
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.