ADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
ADJUSTMENT (Model R200)
ADJUSTMENT (Model R200)
For quiet and reliable final drive operation, the following five adjustments must be made correctly. Side bearing preload Pinion gear height Pinion bearing preload Ring gear-to-pinion backlash (Refer to ASSEMBLY.) Ring and pinion gear tooth contact pattern aaron
Side Bearing Preload
A selection of carrier side bearing preload shims is required for successful completion of this procedure.
1. Make sure all parts are clean and that the bearings are well lubricated with light oil or DexronTM type automatic trans- mission fluid.
2. Place the differential carrier, with side bearings and bearing races installed, into the final drive housing.
SPD527
3. Put the side bearing spacer in place on the ring gear end of the carrier.
SP D894
Using the J-25267 side bearing spacer drift, place both of
4.
the original carrier side bearing preload shims on the carrier
end, opposite the ring gear.
PD-18
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.