Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Gear Components (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Gear Components (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXGear Components (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Gear Components (Cont'd)

DISASSEMBLY

Gear Components (Cont'd)

Remove rear side components on mainshaft and counter

5. gear.

a. Release staking on countershaft nut and mainshaft nut and loosen these nuts. Mainshaft nut: Left-hand thread

Pull out O.D. counter gear with bearing with suitable puller.

b. Draw out reverse counter gear and spacer.

c.

d. Remove snap rings from reverse idler shaft and draw out reverse idler gear, thrust washers and reverse idler gear bearing. Remove speedometer drive gear and steel ball.

e.

Remove snap ring and pull out overdrive mainshaft bearing,

f. then remove snap ring. Remove mainshaft nut. x

g. JIS >:

h. Remove steel roller and washer.

Remove roller bearing and washer.

i.

e Es %

j. Remove O.D. main gear, needle bearing and baulk ring (O.D.).

PIS

k. Remove O.D. coupling sleeve, shifting inserts and shifting

SH insert springs.

SMTO40B Press out mainshaft and counter gear alternately. |. @ Make sure to alternate pressing of mainshaft and counter gear so as not to allow the front surface of one to contact the rear surface of the other.

SMT751A Remove front side components on mainshaft.

6. Remove ist gear washer and steel ball.

a. % ~ rf z

b. Remove 1st main gear and 1st gear needle bearing.

TH ee

ys o/ S

wy

SMT383A MT-14

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.